Maintenance on Vortech G-Trim V9
#1
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Oct 2005
Location: St. Cloud, MN
Posts: 587
Likes: 0
Received 0 Likes
on
0 Posts
Maintenance on Vortech G-Trim V9
Other then sending this unit in to have a rebuild, is there any other maintenance needed on these HU? I was told by the original owner to remove one of the oil lines to clean off a small piece of mesh that helps prevent any contaminants getting into the HU's oiling system. Is there any truth to this?
Also, where can a get get new pulleys for this HU? Right now I'm running a 3.12, but I'm thinking about going with a FMI, so I might up the boost to compensate for the extra intercooler tubing. Thanks
Also, where can a get get new pulleys for this HU? Right now I'm running a 3.12, but I'm thinking about going with a FMI, so I might up the boost to compensate for the extra intercooler tubing. Thanks