Just how far has a stock computer been taken?
#43
LS1Tech Co-Founder
iTrader: (34)
10sec rx7, I don't think I have you on the PlanetLSX Quickest LS Cars list, though I do have a few RX7's on there. Could you email some info to me at john@motorsports-media.com.
#44
FormerVendor
Thread Starter
iTrader: (7)
Join Date: Dec 2004
Posts: 373
Likes: 0
Received 0 Likes
on
0 Posts
I don't think I have much, if any, left in this combo so I'm sure my pass will fall early next season. I need to find a sponsor to toss me a nice 6 bolt motor of some sort! lol. Give me something with 6 bolts, an a2w, and a bs3/xfi and watch the **** out!
#45
FormerVendor
I like 6 bolts, I like a2w but wouldn't bother with changing the stock ECU, it will do just fine
#48
10sec rx7, I don't think I have you on the PlanetLSX Quickest LS Cars list, though I do have a few RX7's on there. Could you email some info to me at john@motorsports-media.com.
Dale
#49
if you find one can you get them to toss me one as well??
#51
6600 rpm clutch dump of death Administrator
Craig from Craig's automatics in Sydney has been low 8's on a stock ECM. I want to say he has been in the 8.0's - 8.10's.... I'll see if I can find his best time to date... I think he and Pete were seeing if they could get the car into the 7.90's.
Edit: Here is an older thread (2006), where they went 8.30's @ 163. I'll have to give Pete a call and see what the current best time is. As I said, I think its low 8's...
http://www.ls1.com.au/forum/showthread.php?t=60925
Edit: Here is an older thread (2006), where they went 8.30's @ 163. I'll have to give Pete a call and see what the current best time is. As I said, I think its low 8's...
http://www.ls1.com.au/forum/showthread.php?t=60925
The engine is still on a soft tune with only 12lb’s boost and 6,800rpm shift point making just over 1,000hp and the car is still heavy at 3,048lb’s race weight so there is still plenty to go!
60’ = 1.19
660’ = 5.33 @ 130.25mph
ET = 8.39 @ 163.55 mph
60’ = 1.19
660’ = 5.33 @ 130.25mph
ET = 8.39 @ 163.55 mph
Last edited by J-Rod; 11-16-2010 at 04:51 PM.