are flat top pistons ok for a supercharger? thinking of buying used motor
#1
are flat top pistons ok for a supercharger? thinking of buying used motor
I have a procharger d1sc that i will use and am thinking of buying this motor...
Thinking 13-15# of boost
I am looking at a Used Forged 402 Short Block 1000 miles
LS2 Block bored to 4.010
Diamond Flat top pistons -2cc
Total seal ring set
Eagle H-beam connecting rods
Eagle Forged Crank 58x reluctor wheel
Clevite main and rod bearings
Will the flat top pistons work well?
Are dished pistons much better and why?
The seller said 317 heads and gm mls gasket will give it a 9.5 to 1
Thanks for the input!
Thinking 13-15# of boost
I am looking at a Used Forged 402 Short Block 1000 miles
LS2 Block bored to 4.010
Diamond Flat top pistons -2cc
Total seal ring set
Eagle H-beam connecting rods
Eagle Forged Crank 58x reluctor wheel
Clevite main and rod bearings
Will the flat top pistons work well?
Are dished pistons much better and why?
The seller said 317 heads and gm mls gasket will give it a 9.5 to 1
Thanks for the input!
#2
LS1Tech Sponsor
iTrader: (16)
13 to 15 psi should be just fine with any forged engine with a good tune and no detonation. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website