slolt1

iTrader: (75)

i just installed my procharger p1sc its a procharger j bracket 6 rib with the manual tensioner
my problem is that the tensioner is going slating down when you put tension on it.the top of it goes into the bracket and the bottom is outward

grpaic

Sound like the tensioner is ready to snap in half, get rid off it

slolt1

iTrader: (75)

gonna pull it today and look at i seen a post on here where some one said the snap rings was bad about breaking

pdasterly

iTrader: (4)

sounds like your belts is misaligned, I would check to see if you used correct length stand-offs

slolt1

iTrader: (75)

the idler tensioner came apart there is no bearings left in it ...