looking at flywheel hp, talking with a shop they say 1k flywheel hp with there engine . now i called magnuson today just to see what they had to say and they advised me the tvs 2300 would not come close to 1k flywheel hp at 15lbs of boost?

 

we've made 900 with a 427. that was about 13 lbs. It didn't have a jackshaft so we couldn't spin the blower any harder. With the correct engine and closer to 18 lbs of we could make 1000hp. I did some simulations on this the other week and it looks very possible. The 2300 flows about the same air as an F1C procharger and we've made 1000 with them.

 

I Couldnt have said it better my self. Dont be affraid of some compression either.

 

Agree that it should be possible. Something like the AES 399 with good heads, E85 and 11:1 compression should make 1k at the flywheel. Just get that blower speed maxxed out and hold on, it would be like driving a modded Duramax around!

 

We have done a 2300 on a 408 that made 770 RWHP 780 RWTQ on just blower. If we can get all the restriction on the inlet side away we will be around 800 RWHP I believe. On a 100 shot it made 895 RWHP and 900 RWTQ. This was on E85.


Zach