well I have pulled my car down again to make some changes that I have been wanting to make...

I have be EXTREMELY busy with my new job and running my own company to boot so finding time to work on my turbo car is hard. Anyway I made a little time tonight to mount my Kurt Urban water vapor system and snapped a few pics of it... Made a plate out of aluminum to mount it to try and make it a clean install...

When I pulled my motor down I have been running 13lbs of boost and the rear pistons were cleaner than the front cylinder? Anyone have this issue? I was thinking it may be due to extr heat at the rear of the motor since I had those steam ports blocked off...

 

did the plugs in the rear look leaner than the fronts?

 

im getting mine in november and i have no idea where to route it to look good with my painted fast 102. id prefer not to see it. if i get longer lines it may affect function. maybe kurt or reckless will chime in about that.

 

No the plugs all looked great front and back.

It is such a nice looking piece I wanted to be able to see it on mine..
I am sure you could hide it though as I have seen it done that way several times..