TheLS1Lover

I 80% sure Brian (Fireball) ran one with his 364/98mm Setup and that was in the 7's, he eventually switched to a Super Vic. but I think that was with the 427/106mm combo.

Stangkilr

iTrader: (47)

Its all in what elbow you use and cylinder heads

87silverbullet

iTrader: (11)

You're right. I remember him selling that setup awhile back.

Twotonefreak

iTrader: (11)

The edelbrock vic jr and their low profile elbow are a great combo. I have zero distribution issues, my plugs actually look better than it did with the stock LS6 with the YSi. Mine is now a 370 and with the YSi it was making a hair over 1k.

allout06

iTrader: (11)

is a spacer required between the elbow and the intake? i seen that someone said they put a 2" spacer to straighten the airflow directly vertical before it hits the intake. Im leaning more and more towards this setup. Any injector fitment issues?

Twotonefreak

iTrader: (11)

I don't have a spacer on mine. I needed the elbow b/c the vette has zero room and I still had to get a new hood to run this set up. Zero injector fitment issues. I also use the Edelbrock rails.

fastcars95

iTrader: (9)

What other elbow options are there for a stock hood. I'm looking to clear a Ta ram air hood.

MATTREDSS

iTrader: (16)

completely agree with this



btw araon/6061 elbow on order

roswald0511

iTrader: (2)

Where to get the araon elbow from?

allout06

iTrader: (11)

6061.com

roswald0511

iTrader: (2)

Thanks.