***Big changes for 2014***
#21
TECH Fanatic
Thread Starter
iTrader: (13)
Join Date: Jan 2009
Location: Fenton, MI
Posts: 1,644
Likes: 0
Received 0 Likes
on
0 Posts
Didn't get anything done tonight. I got the engine leveled,aligned to the rear pinion, with what I think is the correct offset for efficient driveshaft angles. I set the engine to 0*, but I think(depending on Trans choice) I may have to rework the Trans tunnel, not worried about that thought, Ill worry about that later. The car is sitting pretty low, hoping for decent aero. Then went to help a buddy with his Supra.
Next, I am going to plate the Subframe ends, tie them into my cage, and then run the front tubes.
Then, Motor/mid plates.
Thanks man. If I can get the car done, Ill be at Milan every NO ET. The car is going to spec to 10.0 with the 6pt cage. haha
Yea, there is a ton of stuff going on in the area this summer.
Will do, its a learning experience for me, so I will put as much in here as possible.
Thanks!
Next, I am going to plate the Subframe ends, tie them into my cage, and then run the front tubes.
Then, Motor/mid plates.
awesome, yeah, thats a huge shop, look in the byron area, there are a few houses out that way pretty cheap some already have polebarns lol.. my mom lives out there on pierce rd nice and quiet, id like to move back out someday.
car is coming along nicely looks like quite the project, maybe ill see ya around at the track, do you do any meets around here?
car is coming along nicely looks like quite the project, maybe ill see ya around at the track, do you do any meets around here?
Yea, there is a ton of stuff going on in the area this summer.
Thanks!
#25
TECH Fanatic
Thread Starter
iTrader: (13)
Join Date: Jan 2009
Location: Fenton, MI
Posts: 1,644
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys,
Yea. Its a great welder, I've ran the foot welder since I got it and taught myself to weld last year. Yesterday when I was doing some welding it was a bit tight on space, and I tried to use the thumb control, welds actually improved, I got some really consistent dimes, but it is very hard to use, I much prefer the foot control when it allows.
Yea. Its a great welder, I've ran the foot welder since I got it and taught myself to weld last year. Yesterday when I was doing some welding it was a bit tight on space, and I tried to use the thumb control, welds actually improved, I got some really consistent dimes, but it is very hard to use, I much prefer the foot control when it allows.