Procharger Intake Injector Placement?
Thread Starter
Launching!
Joined: Oct 2010
Posts: 257
Likes: 0
From: Ottawa, Ontario, Canada.
Procharger Intake Injector Placement? I am putting on a water/meth injection this year and looking at injector placement? I am thinking 2 injectors to ensure a good mixture. The IAT sensor is on the drivers back side of the intake as you know. Seems like the only place to mount the injectors is 90 deg to the inlet pipes? I don't really want them spraying directly in to the throttle body and I think there would be a better mix going across the airflow? Any thoughts are appreciated, thanks.
My tuner installed my water meth setup and he drilled and tapped the tb , right on the top of it. it doesnt interfere with the silicone adapter either . He also did my friends procharged ta the same way . Until i saw mine and his ive never seen another done this way but it works .
Thread Starter
Launching!
Joined: Oct 2010
Posts: 257
Likes: 0
From: Ottawa, Ontario, Canada.
My tuner installed my water meth setup and he drilled and tapped the tb , right on the top of it. it doesnt interfere with the silicone adapter either . He also did my friends procharged ta the same way . Until i saw mine and his ive never seen another done this way but it works .
its before the throttle body , its at the very top , so as soon as the blade is open about 10 percent it could spray in .
Mine is set to spray at 4 lbs so the tb is fully open when it sprays
Use the washer tank to hold your mixture . Thats where mine is .
Mine is set to spray at 4 lbs so the tb is fully open when it sprays
Use the washer tank to hold your mixture . Thats where mine is .
