Safe boost levels
Thread Starter
TECH Senior Member
Joined: Jul 2009
Posts: 8,032
Likes: 661
Safe boost levels Hi guys,
I have a 30K mile LY6 and I was considering a LSA sc. What is the boost I should be able to put through this until I need to open up the rings? Safe boost levels
thanks,
Jim
I have a 30K mile LY6 and I was considering a LSA sc. What is the boost I should be able to put through this until I need to open up the rings? Safe boost levels
thanks,
Jim
No way of knowing without knowing what your gaps are at. A lot will have to do with the tune and amount of heat in the cylinder. That's not many miles, they are likely still pretty tight. I'd go turbo over the SC. Easier to intercool, make more power per pound, and cheaper. Bigger bang for your buck all around.
As a drastic over simplification, stock LS motors with stock gaps are typically fine to the 600whp level as long as tuning is good. Whatever boost it takes to get there is setup dependent but usually somewhere in the 8-12 psi range from a turbo/blower.
Thread Starter
TECH Senior Member
Joined: Jul 2009
Posts: 8,032
Likes: 661
The stock pistons are good enough for 600RWHP? I’m surprised. I just need to decide if I really want to boost it with that low of miles. I don’t really want to open it up more than just putting in LS3 intake valves.
thanks guys
thanks guys
