Big Thanks to ET Performance!!
Thread Starter
Under criminal investigation for fraud
iTrader: (-2)
Joined: Jan 2004
Posts: 1,350
Likes: 0
Big Thanks to ET Performance!! Just want to say thanks to Cary, Craig, and Mike over at ET Performance cylinder heads. We use their heads exclusively on all of our engines. They have some of best heads out there. The heads on my engine our the 5.3 liter race heads. They have 2.080" titanium intake valves and 1.600" steel exhaust valves. They have soild roller springs on them and also titanium retainers. These heads flow 340 cfm at peak, I will try to post the flow sheet tomorrow. I just thought I would give you guy's some spec's on the heads while I was typing my thank you!!
ET Performance = bad *** cylinder heads!!
Thanks again ET Performance
ET Performance = bad *** cylinder heads!!
Thanks again ET Performance
thanks et Chris
Your welcome. We appreciate the opportunity to work with you guys. We look foward to see how long those heads last with that 55 lbs of boost, lol
Cary and the guys at ETP
Your welcome. We appreciate the opportunity to work with you guys. We look foward to see how long those heads last with that 55 lbs of boost, lol
Cary and the guys at ETP
Thread Starter
Under criminal investigation for fraud
iTrader: (-2)
Joined: Jan 2004
Posts: 1,350
Likes: 0
Kyle, yes those are them! Your's would be the hyd roller form though, unless your stepping up?? 
Cary, you the man!! At 55lbs we are going to have problems I think though
Cary, you the man!! At 55lbs we are going to have problems I think though
