still goin' ...
#42
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Dammit, where was this post yesterday before I broke out the soldering iron and got cramped up inside the engine bay. Now...to re-think. I like the idea you suggested. We sell nothing at retail
![Happy](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_stretch.gif)
Originally Posted by Flipper
Jammer..
Awesome job! Man thats looking sweet!
Hey on your Map wiring for the ls2 manifold what are you going to use for a map sensor? I assume you are talking about moving it to the front of the mani where sthe stock LS2 goes..
I am guessing with those bad boys you are going to run a aftermarket 3-bar Map sensor?
Anyway, what I did was tap the stock hole where the Map goes and threaded it then put a plug in it.. Could use it for a vacum/boost port if needed.. Then used a Accel 3-bar off of one of the outlets on the back of the manifold..
Dont know if that will help but just thought I would throw it out there....
Keep up the awesome pics!!
Awesome job! Man thats looking sweet!
Hey on your Map wiring for the ls2 manifold what are you going to use for a map sensor? I assume you are talking about moving it to the front of the mani where sthe stock LS2 goes..
I am guessing with those bad boys you are going to run a aftermarket 3-bar Map sensor?
Anyway, what I did was tap the stock hole where the Map goes and threaded it then put a plug in it.. Could use it for a vacum/boost port if needed.. Then used a Accel 3-bar off of one of the outlets on the back of the manifold..
Dont know if that will help but just thought I would throw it out there....
Keep up the awesome pics!!
#46
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Originally Posted by Flipper
Jammer,
Is the budget about what you were expecting?
Wolfee,
Any pics of yours yet? Hows it coming along?
Is the budget about what you were expecting?
Wolfee,
Any pics of yours yet? Hows it coming along?
#47
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Originally Posted by Jammer
Flip,more or less... spent a bit more on mandrel bends than I expected..mostly IC pipe stuff. I have too much manderel bent exhaust stuff left... misjudged that. I am within $1000 of what was expected.