How to read compressor maps for twin turbo?
How to read compressor maps for twin turbo? I want to figure out what turbos I should run for a TT setup, but am unsure of how to read the maps for this. Are there seperate maps for TT, or is there some special way of reading this? I read this site http://www.forcedinductions.com/help.htm and understand it, but they dont mention how to read the map for TT. Would the air flow #'s be doubled??
http://www.turbocalculator.com/garrett.html
http://www.turbocalculator.com/garrett.html
Last edited by Lostpatrolman; May 2, 2005 at 01:29 AM.
Guest
Posts: n/a
what i did was divide my airflow by 2. so say, 60lbs/min total, so each turbo needs 30lbs/min on the compressor map at the highest efficiency possible.
if your going to run 5psi, make sure you check it at 5psi, you dont divide that number by 2, just the airflow.
if your going to run 5psi, make sure you check it at 5psi, you dont divide that number by 2, just the airflow.
compression, compressoe, compressor, conference, ls1tech, map, maping, mapping, maps, read, reading, turbo, turbos, twin, twins
