help with 2 step install....????
this is on my 99 turbo SS m6.
1. i have the 2 harnesses plugged into the coil packs on each side
2. i have the white wire going into one side of my momentary switch and then it continues out to a ground.
3. the grey wire is connected to pin# 32 on the blue connector of the pcm(i believe it is a grey wire).
here is my problem. i hit the momentary switch with the clutch in and it enables the 2 step, but whn i dump the clutch, it won't disable my 2 step rev limiter.
this is the only way i have found to make it work.....i tap the momen switch with the clutch in and have my set rev limit...then i hold down the momen switch again and release the switch and the clutch at the same time. i know i shouldn't have to do this but unless i hit that button again, my 2 step won't disable. any ideas?
thanks
i have done a few things since then so i should be low 11's at a good track <img border="0" alt="[devil]" title="" src="graemlins/gr_devil.gif" />

