Extending MAF wires
10-24-2005, 06:15 PM
#1
On The Tree
Thread Starter
Join Date: Jul 2005
Location: Woodstock,GA
Posts: 151
Likes: 0
Received 0 Likes
on
0 Posts
Extending MAF wires I had to extend my MAF wires to about 30" after my Vortech installation.
Has there been any problem(s) that anyone knows of because of extending the wires??
I can't see where it would, being its just low voltage going through them.
Has there been any problem(s) that anyone knows of because of extending the wires??
I can't see where it would, being its just low voltage going through them.
11-23-2009, 09:28 AM
#4
What is the good way and the bad way of extending those wires?
I think the yellow one should be soldered but the other 2 can be put together in any other way because only the yellow one carries a single, the other 2 are just volt and ground!
am I correct?
I think the yellow one should be soldered but the other 2 can be put together in any other way because only the yellow one carries a single, the other 2 are just volt and ground!
am I correct?
