turbo headers with different primary sizing
turbo headers with different primary sizing At this time on my turbo setup i have two 1 3/4 mac headers cut up. One is foward facing, the other is straight down. The drivers side pipe runs under the k member. I would like to change this.
I just picked up a set of gibson truck shorties, theyre 1 5/8. Would there be any huge problems with me running the pass side at 1 3/4 and the drivers side at 1 5/8?
I can always cut up the header i have now and configure it to run over the k member, but this truck header needs almost zero mods to get it to fit compared to the other header i would have to build from scratch again.
I just picked up a set of gibson truck shorties, theyre 1 5/8. Would there be any huge problems with me running the pass side at 1 3/4 and the drivers side at 1 5/8?
I can always cut up the header i have now and configure it to run over the k member, but this truck header needs almost zero mods to get it to fit compared to the other header i would have to build from scratch again.
