Tial 44mm Wastegate issue, HELP!
10-09-2006, 12:45 PM
#21
TECH Apprentice
Join Date: Jan 2004
Posts: 305
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Brains
In the most simple setup, leave both nipples unhooked and you'll run on the spring alone.
In response to the original post. Take a referance line right from the port on the compressor (highest pressure) and run it to the botom side of the gate. Also make sure the top port of the gate is vented. If you still have over boosting issues then you require a larger gate. Its not rocket science.
Dave
10-09-2006, 01:00 PM
#22
TECH Senior Member
iTrader: (7)
Join Date: Jan 2002
Location: Katy, TX
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Where would you get a vacuum reference while in boost? You meant pressure source I'm sure, like from the turbo outlet since you said bottom port.
Yes, in most cases you WILL run very high boost, because the air pressure on the diaphragm can move the valve much easier than pressure on the smaller valve. A 7lb. spring could easily become 15lbs. or more ... I should have clarified, thanks for pointing that out...
Yes, in most cases you WILL run very high boost, because the air pressure on the diaphragm can move the valve much easier than pressure on the smaller valve. A 7lb. spring could easily become 15lbs. or more ... I should have clarified, thanks for pointing that out...
