11 lb. Dyno Numbers
Thread Starter
TECH Enthusiast
Joined: Dec 2002
Posts: 698
Likes: 0
From: Fort Worth
11 lb. Dyno Numbers I installed the 12 lb. pulley and tuned the motor last week, although I ony see 11lbs. So today I went and had it put on the rollers. It made 509rwhp and 499rwtq on the first run. On the second run I added 2deg of timing and put just a touch more fuel in it. The second run made 498rwhp at 6,050 and 509rwtq at 3,500.
All and all I am pretty happy with the results but, I thought it would make more hp than it did. However, it was 92 degs, 93 oct. fuel, 8.5 4.10 gears, and heavy 20 in. rims.
We also tried spinning the motor to 6,500 but I think my cam ran out of sh*t. The power curves went level and the motor just laid over after 6,100.
What do you guys think?
All and all I am pretty happy with the results but, I thought it would make more hp than it did. However, it was 92 degs, 93 oct. fuel, 8.5 4.10 gears, and heavy 20 in. rims.
We also tried spinning the motor to 6,500 but I think my cam ran out of sh*t. The power curves went level and the motor just laid over after 6,100.
What do you guys think?
Thread Starter
TECH Enthusiast
Joined: Dec 2002
Posts: 698
Likes: 0
From: Fort Worth
Re: 11 lb. Dyno Numbers The cam is the only thing done to the motor. The bottom end is stock and the heads have never been off.
I do not use the FMU, I just use the injectors.
A NOS wet kit arrives Wed.
I do not use the FMU, I just use the injectors.
A NOS wet kit arrives Wed.
