Been busy lately pics within :)
Thread Starter
TECH Apprentice
Joined: Nov 2001
Posts: 356
Likes: 0
From: Bellingham, WA
Been busy lately pics within :) Work has been busy in my lil work space. Got 2 sets of headers fabbed up one top mounted turbo system for a buyer in FL, and another set that will be up forsale before long as I just wanted to see if they would work how I thought.
All that is left is to finish weld trim to length and then start on downpipes and intercooler piping which should be cake.
<a href="http://groups.msn.com/Zturbo/fabricatedparts.msnw" target="_blank">Here is the pic page for the 2 sets of headers and other lil tid bits that i have been working on
</a>
Steven
All that is left is to finish weld trim to length and then start on downpipes and intercooler piping which should be cake.
<a href="http://groups.msn.com/Zturbo/fabricatedparts.msnw" target="_blank">Here is the pic page for the 2 sets of headers and other lil tid bits that i have been working on
</a> Steven
Moderator
Joined: Nov 2001
Posts: 3,048
Likes: 12
From: Raleigh, NC
Re: Been busy lately pics within :) Man! You HAVE been a busy bee, haven't you?
I don't think I've read what you are planning here. Can you elaborate, or point to another post where you have?
Thanks.
I don't think I've read what you are planning here. Can you elaborate, or point to another post where you have?
Thanks.
Thread Starter
TECH Apprentice
Joined: Nov 2001
Posts: 356
Likes: 0
From: Bellingham, WA
Re: Been busy lately pics within :) The setup with above the valve cover setup is for a customer running twin 53mm turbos (john craig turbo) Engine will be in the 388 (or whatever the all bore motors are.) Running a air-air intercooler setup.
The headers with the turbos down low are going to be twin 60 mm most prob (have not gotten the turbos for it yet.. but wanting to push the ls1 block a bit more than what i have seen) Will be using one of my air-water intercooler setups, then will put up forsale. I am just having fun with this stuff when i am off work.
The headers with the turbos down low are going to be twin 60 mm most prob (have not gotten the turbos for it yet.. but wanting to push the ls1 block a bit more than what i have seen) Will be using one of my air-water intercooler setups, then will put up forsale. I am just having fun with this stuff when i am off work.
