My build (truck/C6 manifold setup)
#70
Thread Starter
10 Second Club
iTrader: (19)
Joined: Feb 2004
Posts: 2,542
Likes: 2
From: Alexandria La.
Plummed in the oil feed line, made a new power steering line, & finally got my 4" 304 SS pipe & bends. I also welded in an elbow & V-band flange for the new wastegate location. All minor stuff, didnt think anyone would be interested in those pics so I hadnt posted them up. I'm waiting on HP performance to get the 3.5" V band flange to me before I can start building the down pipe. I ordered one from stainless works but the one that HP uses they have machined specificly for them so any other 3.5" V-band flange isnt compatible, I hope it comes in soon so I can get moving on it again.
Last edited by WS6HUMMER; 10-16-2008 at 10:08 AM.
#77
Thread Starter
10 Second Club
iTrader: (19)
Joined: Feb 2004
Posts: 2,542
Likes: 2
From: Alexandria La.
Yeah 4" will fit through there but there's like 1/4" clearance on the sides. Its not a straight shot I dont think either, this one will really test my fabskills.
#78
Yeah, my K-member bulges out to the side where it bolts up to the bottom of the fraim rail, I plan on routing it there.
Yeah 4" will fit through there but there's like 1/4" clearance on the sides. Its not a straight shot I dont think either, this one will really test my fabskills.
Yeah 4" will fit through there but there's like 1/4" clearance on the sides. Its not a straight shot I dont think either, this one will really test my fabskills.