Installing intank and inline walbros.

Reply Subscribe

Thread Tools

Search this Thread

Sep 29, 2003 | 06:17 AM

FLA 98TA

Thread Starter

Launching!

Joined: Apr 2003

Posts: 230

Likes: 0

From: Florida

Installing intank and inline walbros.

I am putting an intank and an inline fuel pump in sometime this week. If anyone has some pointers let me know. Picture would be cool or an install site. Seems like a simple install just gotta pick spot to mount and then wire it.

Thanks for info.
Darrell

Sep 29, 2003 | 01:45 PM

Nasty N8

FormerVendor

iTrader: (33)

Joined: Feb 2002

Posts: 5,052

Likes: 0

From: Lake in the Hills, IL

Re: Installing intank and inline walbros.

Why both? the intank is good for 600+ hp.

Nate

Sep 29, 2003 | 05:57 PM

FLA 98TA

Thread Starter

Launching!

Joined: Apr 2003

Posts: 230

Likes: 0

From: Florida

Re: Installing intank and inline walbros.

450rwhp on motor + a 200shot TNT wet kit. That's about 750 at the crank. No?

Darrell

Sep 29, 2003 | 06:54 PM

JF WS6

TECH Fanatic

Joined: Dec 2002

Posts: 1,084

Likes: 0

From: Bring it........ b*tch

Re: Installing intank and inline walbros.

I certainly hope that's on a FORGED bottom end. If you spray a 200 on a stock one....

Sep 29, 2003 | 09:30 PM

FLA 98TA

Thread Starter

Launching!

Joined: Apr 2003

Posts: 230

Likes: 0

From: Florida

Re: Installing intank and inline walbros.

Going to be. right now I just have a small 100shot. Only 495rwhp

but the bottom end is going to be built soon enough.

Anyone have any info.

Sep 29, 2003 | 09:43 PM

theblur98ss

TECH Junkie

iTrader: (71)

Joined: Mar 2002

Posts: 3,703

Likes: 0

From: East Brady, Pa

Re: Installing intank and inline walbros.

The inline should be easy. The line will snap on at the outlet of the tank and onto the fuel filter. I made that part easy on you. I think I used mightmouse's pics when I did the walbro install. Have fun cause it sucks on a 98 gas tank. Jack the car up and let the rear hang. You'll be able to get the tank down enough to pull the assembly out. Be warned that the fill neck will probably bend and have to be bent back. Also I was seeing 62PSI with that setup.