38 lb. injectors and Edit?
06-18-2003, 07:52 PM
#1
TECH Addict
Thread Starter
iTrader: (6)
Join Date: Nov 2001
Location: Tampa, Florida
Posts: 2,099
Likes: 0
Received 0 Likes
on
0 Posts
38 lb. injectors and Edit? A friend of mine has a '97 Vette with an ATI Procharger running 8 1/2 lb. of boost, Magnaflow exhaust, filter intake, and no cats. his car bogs above 3500 rpm's and he has to shut it off in order for the car to drive normally again. What parameters in Edit need to be modified in order to tell the PCM about the injector upgrade?
I think his stock injectors were 26.
I too am interested in the solution since this is the package I'll be upgrading to in the near future
Thanks!
I think his stock injectors were 26.
I too am interested in the solution since this is the package I'll be upgrading to in the near future
Thanks!
06-18-2003, 09:59 PM
#2
TECH Fanatic
Join Date: Dec 2001
Location: Germantown, MD
Posts: 1,220
Likes: 0
Received 0 Likes
on
0 Posts
Re: 38 lb. injectors and Edit? I just posted up a detailed answer on the LS1Edit e-group, but the short answer is the Injector Flow Rate table. That's what you need to adjust for new Injectors. I gave a few other suggestions in my e-group post. Check it out 
Mike
Mike
06-19-2003, 09:35 PM
#3
TECH Addict
Thread Starter
iTrader: (6)
Join Date: Nov 2001
Location: Tampa, Florida
Posts: 2,099
Likes: 0
Received 0 Likes
on
0 Posts
Re: 38 lb. injectors and Edit? Cool!
Thanks for the reply
That's the parameter I normally adjust . . . I just wasn't sure if the normal parameter changes apply for upgraded injectors
Thank you! I'll check out edit
Thanks for the reply
That's the parameter I normally adjust . . . I just wasn't sure if the normal parameter changes apply for upgraded injectors Thank you! I'll check out edit
