Strange whine?!
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Apr 2010
Location: Worth, IL
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Strange whine?!
I have an m9 with 3:73, 1k on it and it whines from 40+mph. When no gas is applied it stop and when I give it good amount of throttle it stops, I know I probably need gear adjusted.
Here's the kicker, the noise randomly goes away and slowly gets louder, it's random I let off gas then apply and it's quit then other times I apply it and it is whining again....I'm so confused, my brother said might be ujoint, I have stock driveshaft with conversion ujoint.
Can anyone chime in?
Here's the kicker, the noise randomly goes away and slowly gets louder, it's random I let off gas then apply and it's quit then other times I apply it and it is whining again....I'm so confused, my brother said might be ujoint, I have stock driveshaft with conversion ujoint.
Can anyone chime in?
#2
TECH Apprentice
Holy ****. I knew I was not the only one. Bro check out this vid from our Army dude friend, Haans249. As soon as I let off, the noise goes away. Apply gas, it is back. The vid says it all.
http://www.youtube.com/watch?v=GX63NQsG1mg
http://www.youtube.com/watch?v=GX63NQsG1mg
#3
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Apr 2010
Location: Worth, IL
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Yea, but does yours go away randomly? I'll let go of gas than press it and it's quite like no whine nothing then I'll let off and press gas again and it returns...so weird, I'm going to have to get gears adjusted, I find it bs it came from moser like this! Another $500 to get something fixed that shouldn't need to be fixed!
I got tranny problems as well I might fix that first before I can't drive at all, the whine I can deal with it's bad but not horrible.
I got tranny problems as well I might fix that first before I can't drive at all, the whine I can deal with it's bad but not horrible.
#4
TECH Apprentice
Yea, but does yours go away randomly? I'll let go of gas than press it and it's quite like no whine nothing then I'll let off and press gas again and it returns...so weird, I'm going to have to get gears adjusted, I find it bs it came from moser like this! Another $500 to get something fixed that shouldn't need to be fixed!
I got tranny problems as well I might fix that first before I can't drive at all, the whine I can deal with it's bad but not horrible.
I got tranny problems as well I might fix that first before I can't drive at all, the whine I can deal with it's bad but not horrible.
Trending Topics
#8
i have a moser 12 bolt with 3.73 and mine has always done that not as loud as yours but when i checked everything and put new fluid in it and service the rear end nothing looks bad or warn... the gears etc look in good shape to nothing worn or warpped
#9
LS1Tech Sponsor
iTrader: (16)
Gear whine doesn't always mean the gears weren't installed correctly. You can have what appears to be two identical sets of gears installed the same, and one set will have gear whine and the other set won't. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
#10
TECH Apprentice
Just sucks Bob, we don't have a lot of money to go through gear sets and find out if they will be noisy or not.
Last edited by Camaro Junky; 07-07-2010 at 09:11 AM.
#11
FormerVendor
iTrader: (2)
Join Date: Dec 2007
Location: Sacramento, California
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
Holy ****. I knew I was not the only one. Bro check out this vid from our Army dude friend, Haans249. As soon as I let off, the noise goes away. Apply gas, it is back. The vid says it all.
http://www.youtube.com/watch?v=GX63NQsG1mg
http://www.youtube.com/watch?v=GX63NQsG1mg
Any aftermarket set of gears can make noise in this type of vehicle. What brand of gears were used on the build? We like to use the Motive Performance or the US Gear. We have found there is less of a chance of gear noise and if there is gear noise that it is minimal.
Jeff
#14
On The Tree
iTrader: (2)
Join Date: Jan 2010
Location: El Paso, Tx Southwest Drags
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
What gear oil are you running and where you filling it up to? I had the same problem on a new rear. switched to the 85 140 lucus oil and has toned down some. Its not near as bad, and I can cut it out with the radio on low now and I have 4.11 gears. Give it a shot man.. mine was just as loud as yours if not louder. still having problems with the wavetrac a bit but.. not sure what that is. It likes to pull to the right under power but if I get on it at a stop both tires spin.. so it might just be how wavetrac works..
#15
TECH Fanatic
iTrader: (10)
Join Date: Aug 2004
Location: Rochester,Ny
Posts: 1,433
Likes: 0
Received 0 Likes
on
0 Posts
my richmonds are as loud as the ones in the vid,i am going to drive on em for a couple years and beat on em and then change them out to some motives or something.I have a midwest rear,with solid torque arm and aluminum center.
#16
TECH Apprentice
What gear oil are you running and where you filling it up to? I had the same problem on a new rear. switched to the 85 140 lucus oil and has toned down some. Its not near as bad, and I can cut it out with the radio on low now and I have 4.11 gears. Give it a shot man.. mine was just as loud as yours if not louder. still having problems with the wavetrac a bit but.. not sure what that is. It likes to pull to the right under power but if I get on it at a stop both tires spin.. so it might just be how wavetrac works..
My rear did the same thing pulling to the right. I changed the shocks and it went away. How old are your shocks in the back?
#18
LS1Tech Sponsor
iTrader: (16)
Richmond do tend to be louder than Motive and US Gear. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
#19
#20
FormerVendor
iTrader: (2)
Join Date: Dec 2007
Location: Sacramento, California
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
Jeff