Backing Plates - Swap 3 to 4 Channel
#1
Backing Plates - Swap 3 to 4 Channel
This may be an obvious question but, would there be any issues installing 3 channel backing plates unto a 4 channel rear axle? (ie: reluctor wheel clearances, etc)
Thanks,
Jim
Thanks,
Jim
Last edited by BlackBirdDaddy; 03-23-2011 at 09:21 PM.
#4
Let me clarify. I am installing a complete 4 channel rear end (minus the backing plates) into my 3 channel vehicle. Traction control is not needed.
I was wondering if the 3 channel backing plate will bolt to the 4 channel rear end housing without clearance issues.
Thanks,
Jim
I was wondering if the 3 channel backing plate will bolt to the 4 channel rear end housing without clearance issues.
Thanks,
Jim