Vibration after rearend install
#21
TECH Apprentice
Thread Starter
iTrader: (6)
Join Date: Jul 2008
Location: Ottumwa, IA
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
Before install. Yank ss3600, flt lvl7 with billet shafts, speed inc chromoly driveshaft and a pst aluminum shaft, s60 with locker, stock length, umi adj. Tq arm and lower control arms, umi subframe connecters
#40
You said you tried 2 different driveshafts, what yoke(s) did they use? I had a yoke from strange that just didnt fit in the tailhousing right. It wobbled a little, like it was loose in the bushing or the splines werent cut right. I bought a new yoke from Mark Williams and it fixed the problem. Also verify that the driveshaft is the correct length, that could cause the same problem.
Ryan
Ryan