[89ROC-Z]

Looking for the best price and value. Absolutely will not pay more than $450 shipped.

I have a built t56 with a 32 spline output shaft, and a stock 10 bolt. I will be upgrading to a 9" in the future, but I need to pay next falls tuition so a $2500 rear end is out of the question. When I get the 9" I'll sell this shaft and buy the 1" longer shaft for the 9".

So I need a 32 spline yolk on a shaft that will fit with the stock 10 bolt. As long as it holds 620rwhp i'll be happy!

Let me know what you have! I need to order this by next tuesday, and a sale is guaranteed!

thanks

[Bob@BruteSpeed]

Originally Posted by 89ROC-Z

Looking for the best price and value. Absolutely will not pay more than $450 shipped.

I have a built t56 with a 32 spline output shaft, and a stock 10 bolt. I will be upgrading to a 9" in the future, but I need to pay next falls tuition so a $2500 rear end is out of the question. When I get the 9" I'll sell this shaft and buy the 1" longer shaft for the 9".

So I need a 32 spline yolk on a shaft that will fit with the stock 10 bolt. As long as it holds 620rwhp i'll be happy!

Let me know what you have! I need to order this by next tuesday, and a sale is guaranteed!

thanks

Send me a pm. Thanks. Bob

[HoLLo]

I did a lot of discussing with vendors on driveshafts. I ended up with a Strange chromoly 3" driveshaft for my 9" rear. Solid piece. And it was under $300 shipped. Since you got a $450 limit, go ahead and get a PST 3.5" aluminum shaft and shave a few pounds off rotating mass.