Driveshaft Length with a 9" Rear with a Forged 1350?
#1
Driveshaft Length with a 9" Rear with a Forged 1350?
The driveshaft I have now is a 3.5" aluminum unit built with a 41.25" center-to-center length... using a Sonnax 6081 Forged Yoke.
I'm looking at doing a 9" with a Strange Pro Case with the S-Trac. I've seen the Forged 1350 yoke is about 1" longer. Since the 9" typically needs somewhere around a ~42.25" driveshaft, would the Yoke take up the slack and allow me to use my current driveshaft without switching? Of course, until I get it and measure, I won't know. Just looking for anybody's guesstimate.
I'm looking at doing a 9" with a Strange Pro Case with the S-Trac. I've seen the Forged 1350 yoke is about 1" longer. Since the 9" typically needs somewhere around a ~42.25" driveshaft, would the Yoke take up the slack and allow me to use my current driveshaft without switching? Of course, until I get it and measure, I won't know. Just looking for anybody's guesstimate.
#2
TECH Apprentice
Hold off, with my Strange Pro HD and Sonnax Yoke, my driveshaft ended up being stock length believe it or not. My "x" measurement in the attached photo was 44 7/8.