dnm12

iTrader: (13)

So far about the only place I have looked is inland empire...

anyone else got any places to order alum driveshafts for my setup up, meaning the 9" and viper tranny bigger pinion yolk and tranny yolk

TIA!!!!

dnm12

iTrader: (13)

no love??????????? Anyone??

EPP

iTrader: (22)

http://www.exoticperformanceplus.com....html?item=827 Bob

dnm12

iTrader: (13)

anyone else got any advice not from a sponser (no offense sponsers but your obviously motivated by something I am not)

dnm12

iTrader: (13)

help? please looking at either denny's or inland empire?

ChocoTaco369

i have an inland empire for my 10-bolt. no complaints.

Dragula

iTrader: (5)

PST 3.5" aluminum here. No problems here.

Jake@EPP

Even though im a sponsor, i HIGHLY reccomend PST, we have had zero failures with them. There warranty is second to none. Custom length for $385!

mullenh

iTrader: (1)

go to the junk yard find a crown vic and get it cut down and balanced at a clutch shop, they will put all of the ends on too. got mine out of a police cruiser but i will bet there are some trucks out there too that would work... cost? $150 or less maybe i don't know.. I got the drive shaft free and they clutch shop owed me so that was free and the parts were less than $20

dnm12

iTrader: (13)

fill me in whats a PST?

dnm12

iTrader: (13)

bump for the above question, wonder if this will get an answer this early on superbowl sunday

mullenh

iTrader: (1)

Precision Shaft Technologies......they make drive shafts even carbon fiber.

EPP

iTrader: (22)

We used a PST 3.5" aluminum driveshaft on this T/A, which is rated at 1200 hp. We sell a lot of these driveshafts, and have never had a problem with them. Bob

dnm12

iTrader: (13)

prices??

EPP

iTrader: (22)

$385.00 plus shipping. The link to it is in my first post. Thanks. Bob