Slip Yoke Depth
Thread Starter
Launching!
Joined: Dec 2001
Posts: 232
Likes: 0
From: Little Rock, AR
Slip Yoke Depth Searched on this but did not get a definitive answer.
</font><blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:</font><hr /><font size="2" face="Verdana, Helvetica, sans-serif">What are the nominal and minimum slip yoke depths?</font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">I have a 9" rear with a Moser 1350 yoke and a stock aluminum shaft. Just set it up and my slip yoke is out about 1 1/2" from the tranny tail.
I'm going to run a cam/headers/stock heads car with an A4, 4.11 gears and 28" ET streets. Of course want to make sure that there is sufficient, safe depth on the slip yoke.
Thanks.
</font><blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:</font><hr /><font size="2" face="Verdana, Helvetica, sans-serif">What are the nominal and minimum slip yoke depths?</font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">I have a 9" rear with a Moser 1350 yoke and a stock aluminum shaft. Just set it up and my slip yoke is out about 1 1/2" from the tranny tail.
I'm going to run a cam/headers/stock heads car with an A4, 4.11 gears and 28" ET streets. Of course want to make sure that there is sufficient, safe depth on the slip yoke.
Thanks.
