Colonel... looking for TC slippage data
Thread Starter
On The Tree
Joined: Dec 2002
Posts: 176
Likes: 0
From: Orlando, FL
Colonel... looking for TC slippage data Colonel,
I'm most likely going to purchase a TCI TC tomorrow but I'd like to know what the slippage rate is at the top end on your 3500. Do you have any A-tap data on this? If not how much alcohol do I need to send up to get some? <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Later!
Tim
I'm most likely going to purchase a TCI TC tomorrow but I'd like to know what the slippage rate is at the top end on your 3500. Do you have any A-tap data on this? If not how much alcohol do I need to send up to get some? <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Later!
Tim
TECH Senior Member
Joined: Nov 2001
Posts: 9,246
Likes: 3
From: Troy, AL
Re: Colonel... looking for TC slippage data Sounds like you need some Autotap data comparing input to output speed. I don't have that. About the closest I can get you right now is telling you my RPM across the line/MPH/ and what the RPM should be if the converter were locked.
OR...
I can just go out and make a couple of Autotap runs of the input and output speeds. <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" /> No <img border="0" alt="[chug]" title="" src="graemlins/gr_chug.gif" /> needed but maybe next time I'm around the Orlando area you can gimme da hookup on some dyno tuning? <img border="0" alt="[burn out]" title="" src="graemlins/gr_burnout.gif" />
OR...
I can just go out and make a couple of Autotap runs of the input and output speeds. <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" /> No <img border="0" alt="[chug]" title="" src="graemlins/gr_chug.gif" /> needed but maybe next time I'm around the Orlando area you can gimme da hookup on some dyno tuning? <img border="0" alt="[burn out]" title="" src="graemlins/gr_burnout.gif" />
