RAM VDS Question, need suggestions
Thread Starter
The Bull
Joined: Jun 2002
Posts: 3,578
Likes: 2
From: Grand Rapids, MI
RAM VDS Question, need suggestions This spring I'm looking at upgrading some stuff and the clutch is going to need to be replaced. I currently have a McLeod single disk and I'm not pleased with it (it is better than stock though). I'm looking at the RAM VDS setup and was curious what setup would take over 500 NA HP and possibly some nitrous as well. I'd like for it to be reasonable on the street. The car is still streetable and will remain so, but I'm stepping up for some racing as well. I'm curious as to what each of the RAM setups are good for and what your thoughts may be.
<small>[ February 09, 2003, 08:02 PM: Message edited by: derty ]</small>
<small>[ February 09, 2003, 08:02 PM: Message edited by: derty ]</small>
FormerVendor
Joined: Nov 2001
Posts: 494
Likes: 0
From: Louisiana
Re: RAM VDS Question, need suggestions The 910 VDS system is going to be able to handle the power you are talking about. It is streetable, has low amount of shutter to it and can be slipped with no problems. Right now we have the 910 in our Project vehicle, it is driven on the street daily, makes 460 rwhp NA and 580 rwhp on 150 shot of nitrous. Best et so far is 10.09 and the clutch has performed outstanding.
Good luck on your decision, let me know if you have any other questions. We are a distributor for RAM so give me a call when your ready for that clutch <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
<small>[ February 09, 2003, 09:49 PM: Message edited by: Candy ]</small>
Good luck on your decision, let me know if you have any other questions. We are a distributor for RAM so give me a call when your ready for that clutch <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
<small>[ February 09, 2003, 09:49 PM: Message edited by: Candy ]</small>
