No power steering after new pump & rack
#1
On The Tree
Thread Starter
Join Date: Dec 2008
Location: Youngstown, Ohio
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
No power steering after new pump & rack
So I had a power steering leak, saw it was coming from the pump so I replaced it. After an hour of driving I lost power steering, when I got it home and got under it I saw that my rack was now leaking by the input shaft under load. So I replaced the rack. Flushed the system which had no contaminants in the flushed fluid. Burped all the air out by turning lock to lock until the bubbles stopped.
Now I have a new rack, new pump, new fluid, and still no power steering.
The car is a 2000 and I got the correct 00-02 rack.... I'm at a loss, I have no idea where to go from here, any ideas or advise would be greatly appreciated.
Now I have a new rack, new pump, new fluid, and still no power steering.
The car is a 2000 and I got the correct 00-02 rack.... I'm at a loss, I have no idea where to go from here, any ideas or advise would be greatly appreciated.
Last edited by 6spdscreaminchickin; 07-22-2016 at 06:44 PM.
#4
On The Tree
Thread Starter
Join Date: Dec 2008
Location: Youngstown, Ohio
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
It was hooked up right, I don't remember what it was but I figured it out. Not sure why I didn't get back on here and post that it was worked out.