Need a torque spec...
Need a torque spec... I had to loosen those two bolts that go through the tranny into the oil pan to drop the pan a bit. Forget the size of them...13mm or 15mm?
Anyway I have searched and found nothing on what it should be torqued to. I remember reading a while ago though thats its around 35 lb ft?
Thanks for the help.
Anyway I have searched and found nothing on what it should be torqued to. I remember reading a while ago though thats its around 35 lb ft?
Thanks for the help.
if they are the long ones that go into the rear cover they are 12nm (about 8 ft-lb i think)... if they are the pan bolts, then its 18. For future refrence, http://www.ls2.com/boggs/torques/eng...tm#Application
37 ft/lbs DUH!!! 
This is what i though was right, but i checked ls1howto.com anyway
He has a whole page with specs on it.
http://ls1howto.com/index.php?category=1
Hit controll F and type housing if you dont believe me
This is what i though was right, but i checked ls1howto.com anyway
He has a whole page with specs on it.http://ls1howto.com/index.php?category=1
Hit controll F and type housing if you dont believe me
Your a good man!
Thank you.
Thats the first place that I looked actually. I was not sure if that was what I was looking for or not though...cause I dont know what the hell its called
Thank you.
Thats the first place that I looked actually. I was not sure if that was what I was looking for or not though...cause I dont know what the hell its called
