Super Victor
Thread Starter
Staging Lane
Joined: Sep 2006
Posts: 60
Likes: 0
From: Northern KY
Super Victor I want to retrofit one to my truck motor.
I have the elbow all figured out. But....
What fuel rails do you use? Edelbrock set?
What injectors will I need? Can I use the Truck injectors?
What fuel regulator does everyone use? The ones I see are red but no name?
Also they don't seem to be vacuum?
Thanks for the input.
I have the elbow all figured out. But....
What fuel rails do you use? Edelbrock set?
What injectors will I need? Can I use the Truck injectors?
What fuel regulator does everyone use? The ones I see are red but no name?
Also they don't seem to be vacuum?
Thanks for the input.
If you buy the Edlebrock rails from Summit it comes with the rail install kit. Not the braided hoses but the rails mounts you need.
You can also use any set of aftermarket rails & injectors but you will have to make your own pieces to hold the rails in tight on the intake. Which shouldn't be hard to do with some scrap metal & drill.
On the FPR look at getting this one. It's Aeromotive & is what you'll need. Nicely priced also. It's the one I"m goin with.
Summit part #: AEI-13105
Jeg's part #: 027-13105
You can also use any set of aftermarket rails & injectors but you will have to make your own pieces to hold the rails in tight on the intake. Which shouldn't be hard to do with some scrap metal & drill.
On the FPR look at getting this one. It's Aeromotive & is what you'll need. Nicely priced also. It's the one I"m goin with.
Summit part #: AEI-13105
Jeg's part #: 027-13105
Thread Starter
Staging Lane
Joined: Sep 2006
Posts: 60
Likes: 0
From: Northern KY
Thank you for the replies.
Good info.
I expect that the super victor is overkill and for a mid cammed 5.3 and not the best performance solution, but it looks a whole lot better than the truck intake! And will fit with the right elbow and by acc setup.
And will hold the future mods to come.
Thanks again.
Good info.
I expect that the super victor is overkill and for a mid cammed 5.3 and not the best performance solution, but it looks a whole lot better than the truck intake! And will fit with the right elbow and by acc setup.
And will hold the future mods to come.
Thanks again.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
