help me remove my PCV system

Reply Subscribe

Thread Tools

Search this Thread

Oct 28, 2008 | 12:55 AM

slowjoe99

Thread Starter

TECH Enthusiast

iTrader: (7)

Joined: May 2007

Posts: 621

Likes: 1

From: MO

help me remove my PCV system

Which nipples on the valve covers and intake do I block off, and where do I put the breather filters to remove my PCV system?

Also, what size of filters do I need to get?

I just want to extra crank case pressure to vent to the open air instead of being vaccumed into my intake because oil is being sucked into the intake.

Oct 28, 2008 | 09:21 AM

conan

TECH Senior Member

iTrader: (5)

Joined: May 2004

Posts: 6,492

Likes: 6

From: Back in the Burg

I caped off the rear plug on the pass side rocker cover and the intake manifold. Then ran the front of the pass side rocker cover and the rear of the driver side rocker cover to a vented catch can that i made my self.
http://mycarpics.shutterfly.com/239
http://mycarpics.shutterfly.com/240
http://mycarpics.shutterfly.com/241

This was my thread in the fi section when I was in need of some pcv help.
https://ls1tech.com/forums/forced-induction/1004298-guys-vented-rocker-covers-inside.html

Oct 28, 2008 | 10:33 AM

crainholio

TECH Addict

iTrader: (2)

Joined: Aug 2003

Posts: 2,977

Likes: 3

I'd consider adding a catch can before I discarded the PCV completely as you're describing.

Vacuum in the crankcase helps the rings stay properly seated, which is a *good* thing.

Reply Subscribe