Searching for a cut out
#3
TECH Enthusiast
Thread Starter
found it at Maryland speed, Any idea about where to install these, i was thinking about one between the y and the resonator, i have about a 10 inch section of almost straight, its sort of offset at both ends,
or should i put one on each side right beforethe two sides merge into one,
or should i put one on each side right beforethe two sides merge into one,
Last edited by metalmechanic; 12-23-2008 at 10:32 AM.
#4
We have these on sale here-
http://marylandspeed.com/dmh-low-pro...ut-p-1313.html
And here they are installed on an F-body...I love this setup because it has the potential to give you actual power.
http://marylandspeed.com/dmh-low-pro...ut-p-1313.html
And here they are installed on an F-body...I love this setup because it has the potential to give you actual power.