BadMonkey

iTrader: (1)

These are just pics of the kit for now. I will be installing this later this week provided my Y pipe gets here in a timely manner. Anyway, I will keep this thread updated as I know there a few of these running around but not very many posts about them. So I figured I would share. I got them through TByrne. They always have great prices on stuff. Here you go. The begining

BTW Part No: 16723
Here is a soundclip from Magnaflows website
http://www.magnaflow.com/04sound/domestic/transam.html

02silvaZ

iTrader: (12)

good luck, cant wait to see pics of it on the car

RedRocketZ28

iTrader: (19)

Looks really nice man. Can't wait to see the pics either.

Grifter

iTrader: (12)

It looks like you have a Borla on the car now. Any reason for going to the Magnaflow?

ReFtheMC

iTrader: (6)

Those tips look good

Hardtop

iTrader: (3)

I have the same system on my car. It looks and sounds great.

BadMonkey

iTrader: (1)

I got rid of the Borla only because it was too loud with my setup. I got rid of my QTP LT's, as well and my lumpy cam. I am getting closer to a sleeper. I should still have good power around 480RWHP I figure even with the downsizing. Sometimes being loud is just not fun anymore.

97BlackLT1TA

iTrader: (4)

Is this the same muffler they run on the other f-body system?

adillhoff

Getting old huh? haha just messing with ya

98nosz28

iTrader: (1)

How loud is this? I am looking for a new system b/c I am going to daily drive my camaro this yr. I have the dyno mouth right now. I leave for work at 5.30am so I need something that is not as loud.

Thanks
Ryan

BadMonkey

iTrader: (1)

I might be

BadMonkey

iTrader: (1)

Yea that is along the line of me getting something else as well. I leave early to go to work then drive through a bunch of houses early in the morning. Besides that I hate hearing the popping of ORY pipes. This kit should be pretty tame. The blower may push up the sound a bit especially with the 10-12 lbs I will try and run. But from most guys I hear the magnaflow alittle easier on the ears. Once I get the tune staright again, and the exhaust installed I will post vids and more pics. This whole project was to be a Daily Driver in mind.

DaveX

I am with you on the too loud. My setup below is still too loud, even with a LM muffler in the I pipe. I think it's largely because I'm running 8.7 dcr and large port heads. I hope yours is quieter than mine with the magnaflow. I'm going to swap it out for a slp dual/dual.

BadMonkey

iTrader: (1)

Damn Dave you are not too far from me. I plan on running stock cats and SLP Ypipe, so it should be just about right. I want to try this. If it is not quite enough then I am jumping into a DD as well.


SOUND CLIP FROM MAGNAFLOWS WEBSITE
http://www.magnaflow.com/04sound/domestic/transam.html

tripps

iTrader: (7)

I have a magnaflow setup but unfortunately I wasn't able to get those tips!! They look amazing though and I know you will love it.

DaveX

Yeah I'm right up the road. I see your running a s/c. I'm not sure how loud yours would be by comparison. I had the tsp cat Y on mine and it sounded better but I had to take it off because my car is too low and the drivers cat rubbed on the bottom of the car (the torque arm I think it was) or on the ground if I tried to adjust it for clearance.

I'm curious where you had your car dynoed? I know there is one in Lex but haven't had my car on it.

Twigs

iTrader: (3)

lets see some pics!

Numba1Stunna

iTrader: (4)

i have the magnaflow as well but with the regular tips. Both hangers broke off on the passenger side so I bought the autozone tips on clearence for $23 each should have em on next week

GTObsessor

iTrader: (2)

Pretty system. I hear ya on louder != cooler/better. I'm about to add two 12" Magnaflow ovals after my X-pipe and most consider my exhaust tame already. Sleepers make much better DDs

BadMonkey

iTrader: (1)

I have dyno'd at SR Racing in Lex. But I normally go to Hoofin Motorsports in Laurenceburg, he has a dyno in his shop in the backyard. Good guy too is pretty reasonable and his dyno is pretty close to being on the mark with the others. But I have been going to Decatur IN to get it done at LM Speed until the tune is straight tht is. Man I wish I had my own dyno