mcalus

iTrader: (14)

Currently I have Pacesetter LTs, ORY and a dumped cherrybomb glasspack. For starters the cherry bomb has to go. So I am looking for a nice glasspack that is pretty short so I have room to run it over the axle and out the back. Any suggestions? Its hard to get the true sound of them on ls1sounds

mcalus

iTrader: (14)

Sorry that ^^^ was written at 7am.

What I am going for is basically a loudmouth setup that looks like this (to some extent) http://www.byunspeed.com/product_inf...d738cbd5ed0493

But It will be put together by an exhaust shop, well the over the axle part. I have heard a lot of bad things about the loudmouth bullet. So what I am looking for is something different. I want to be loud but clean.

Anyone tried this? http://www.summitracing.com/parts/WLK-24222/

Thanks for any suggestions.

Unertl42

iTrader: (63)

I you want it loud, why don't you run true duals? Here is Texas Speed's version
http://www.texas-speed.com/shop/item...d=196&catid=56
Thats what I would do, true duals sound 100 times better than the SLP shitmouth, IMO

mcalus

iTrader: (14)

Well I totally would but $430 bucks for the duals, then about 200 to have an exhaust shop run them out the back would be ~$630 I am not looking to spend vs the $50 for a bullet and ~$150 out the back. I have been running a dumped exhaust on this car for about 3 years, I am not looking to dump anything again anytime soon.

Unertl42

iTrader: (63)

ok, I haven't run the dynomax bullet, but I have run a Magnaflow bullet, same difference. It sounded good, but WAY too loud for me

99SSJarhead

iTrader: (2)

Before I swapped to TSP duals mine was a Y-pipe into an I-pipe, over the axle that then split with another Y-pipe into two resonators and then out the back. It was pretty loud even with shorties and a 2.5 inch pipe all the way out.

mcalus

iTrader: (14)

So I have been reading more and more, would it make a difference if I did 2 dynomax bullets vs 1?