SLP Lid won't stay on!!!
Thread Starter
TECH Enthusiast
Joined: Jan 2004
Posts: 611
Likes: 0
From: Fairfield, CA
SLP Lid won't stay on!!! I got an SLP lid from LMPerformance.com and I keep having problems with the front clips popping off. After reading GMHTP article last month and reading how tight the fit was, I was sold, but the front clips won't stay on. The 4 "pegs" in the back of the box seem to be a bit too big, would it hurt to file these down so the box slides back more because that is my only option I think. Has anyone else had this problem?
Thread Starter
TECH Enthusiast
Joined: Jan 2004
Posts: 611
Likes: 0
From: Fairfield, CA
You guys are awesome, I just went and did that and I finally got that snap from the front clips that assures me it won't pop off. I really appreciate it. One quick question, I had been driving around with the front lip outside the front of the box, would that cause me to lose any hp (would putting it on correctly give me more hp than the way it was on before)?
I had a similar problem wiith my TSP lid. At first I thought it was just due to the lid not sitting in the groove on the lower half of the air box but my problem was due to the SLP Bellows needing to be trimmed. I was able to get my lid to sit in the groove in the front but it would still pop off until I trimmed the bellows. Hopefully sitting yours in the groove will do the trick.
