ARH Headers ?
#1
12 Second Club
Thread Starter
ARH Headers ?
So Im strongly considering arh headers but my question is to the guys who have them. Has anyone had problems with the y pipe banging the floor board either with the ory or catted y pipe. Now I know everyone says to do motor mounts but plain and simple I just don't want to. I feel that if the oem pipe didn't bang a set of well engineered pipes shouldn't either. I heard that arh flattens a section of there y pipe like the oem to prevent this problem and if so that's great! So anyone running this setup please share your expierence. Also arh if your out there please chime in aswell. Thanks
#5
TECH Resident
iTrader: (20)
I had them on my 01 NBM Z/28. They are great headers, fit and finish wise, far better than the QTP LTs I pulled off. You will get a banging y-pipe without upgraded motor mounts, would probably do a poly trans mount as well. That being said, would do the TSP 1 7/8 LTs in heartbeat, they look top notch, made from SS and you cannot beat that price!
Last edited by 03Sssnake; 05-30-2012 at 10:08 AM.
#6
TECH Fanatic
I have ARH 1-7/8" LT's and their ORY. I had no banging with the stock y-pipe and rubber MM's but I replaced the MM's with poly during the header install.
No, my ARH y-pipe doesn't bang at all.
No, my ARH y-pipe doesn't bang at all.
#7
12 Second Club
Thread Starter
I had them on my 01 NBM Z/28. They are great headers, fit and finish wise, far better than the QTP LTs I pulled off. You will get a banging y-pipe without upgraded motor mounts, would probably do a poly trans mount as well. That being said, would do the TSP 1 7/8 LTs in heartbeat, they look top notch, made from SS and you cannot beat that price!
Trending Topics
#8
honestly the arh headers are top notch, i love the sound they make and the quality is great. i do unfortunately have a banging y pipe so what i did was take header wrap and wrap the y pipe in the 1 area where it hits and now its all snug and doesnt move
#10
12 Second Club
Thread Starter
Ok that's what I was looking for some honest advice. Is your y pipe with or without cats? Also that's a good idea to wrap the area with header wrap
#11
TECH Resident
iTrader: (20)
EDIT: I had the ARH catted y-pipe as well.
#15
12 Second Club
Thread Starter
I agree that polys are a great upgrade. But my thought is that for the price I'm gonna be spending on these headers there should be no problem with stock mounts. Now if I was throwing in eBay headers or pacesetters that's a different story
#16
TECH Fanatic
I have no banging, had no install problems, while doing it in 30 degree weather while snowing under a open carport. I have the ARH with their catted Y with my stock mounts. I have no complaints about ARH, best thing I did was buying these headers. Yes I saved up and glad I did.
#17
TECH Regular
iTrader: (12)
I get what you're saying here but why would you even want stock mounts? A performance car should have quality engine mounts. I'm saying why would the need to upgrade $50 mounts make or break wanting to buy their headers? And talking about stock y pipes not banging, look how flat they are.