Intake swap questions
Thread Starter
Staging Lane
iTrader: (10)
Joined: Dec 2010
Posts: 97
Likes: 0
From: Wasaga Beach, Ont, Canada
Intake swap questions Ok so Im swapping to a FAST 92 as my LS6 intake rear vac port broke off on the weekend. I have a few questions about swapping it over.
1 will the stock bolts from the LS6 work with the Fast intake?
2 what is the torque specs for the fast intake to be bolted down
3 is there anything to look out for while installing it
Thanks Guys
1 will the stock bolts from the LS6 work with the Fast intake?
2 what is the torque specs for the fast intake to be bolted down
3 is there anything to look out for while installing it
Thanks Guys
Thread Starter
Staging Lane
iTrader: (10)
Joined: Dec 2010
Posts: 97
Likes: 0
From: Wasaga Beach, Ont, Canada
when you say the coolant lines that go from each side under the throttle body if so yes i already have them on and im replaceing the LS1 valley cover with a LS6 valley cover
And even if u get a LS6 valley cover you still need the button head bolts.
Thread Starter
Staging Lane
iTrader: (10)
Joined: Dec 2010
Posts: 97
Likes: 0
From: Wasaga Beach, Ont, Canada
I bought a set of those bolts you are talking about from another Tech member this morning. I just hope all the parts show up by next week. Cool man thanks for all the info
Staging Lane
Joined: Jun 2012
Posts: 51
Likes: 0
From: Riverside ca
I don't know what you plan on doing with the ls6 intake but you can remove the vacuum port & plug it with a freeze plug. It is 1 31/32" which I sourced out to a Dorman 555-042. Just use some 3m weatherstrip adheasive & push it in. Also, I am in the middle of a ls6 intake swap from a truck intake & am trying to get someone to make a plug that will take the stock o'ring & accept the map sensor. I need to pm a few people to see what will come of it. If all else fails there is a machine shop around the corner that can do the job. I just don't want to have to pay for several prototypes if I don't have to.
