Custom dual question
Thread Starter
Joined: Nov 2005
Posts: 2,148
Likes: 4
From: Gainesville, GA
Custom dual question Does anyone know what angle is needed to go from the drivers side header to mate up to a generic dual kit? It looks like a 15° bend would get the job done, but I haven't put the car in the air or ripped the old exhaust off to measure. I'm sure that a 15° or a 30° would work with the right chopping of the chop saw, lol. I'm just curious as to which you guys typically use.
Does anyone know what angle is needed to go from the drivers side header to mate up to a generic dual kit? It looks like a 15° bend would get the job done, but I haven't put the car in the air or ripped the old exhaust off to measure. I'm sure that a 15° or a 30° would work with the right chopping of the chop saw, lol. I'm just curious as to which you guys typically use.
