Undertow74

iTrader: (45)

Yea well the front crossover that I put on the rear I had to bed it a few ways before I got it on there to make sure there was enough clearance and wouldn't rub. Haven't had any issues yet, and that's been with wot dyno pulls also.

Bama99z

iTrader: (7)

It would of been easier if the manufactures of the head plates would of installed 45 degree fittings rater than straight fittings. I have ordered some fittings and if everything works out as I have planned I will post up some pictures once I figure it out. Wish me luck!!!