LS7 clutch?
#1
On The Tree
Thread Starter
Join Date: May 2013
Location: York, PA
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
LS7 clutch?
i had a spec clutch in my car that went out on christmas, i put a ls7 clutch and flywheel about a month ago. about a week ago i did a burn out through 1st and 2nd i went to hit 3rd and the clutch pedal was almost on the floor, i pumped it and has been fine for almost a week my car started spinning the other day so i layed into it and it was on almost on the floor again, any idea what would cause this? someone told me it might be slave cylinder?
#3
TECH Resident
#4
On The Tree
Thread Starter
Join Date: May 2013
Location: York, PA
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
yes clutch fluid is ok when i got the car the fluid was black and kind of thick i flushed it before the clutch went out and has been fairly clean since
#6
On The Tree
Thread Starter
Join Date: May 2013
Location: York, PA
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
only mods i have is long tubes, 3" exhaust, slp lid and short throw. at the time my clutch went in my brother did most of it as i work 6-7 days a week so i was limited on time he told me the slave cylinder and throw out bearing looked good so i didnt mess with it, i wanted to go with a tick master cylinder, im going to try what N20zuki posted and if that doesnt work i guess ill be buying a slave cylinder. i just dont want to mess up this clutch as i just installed it