True Dual ??
Thread Starter
10 Second Club
iTrader: (7)
Joined: Feb 2004
Posts: 2,070
Likes: 1
From: Victoria, TX
True Dual ?? I am looking into getting a true dual set up. The problem I am having is finding a place that does mandrel bending. For those of you in Texas, who did yours?? Everyone in the TX section says Deer Park, but they don't do mandrel bending...
Thanks
Thanks
Very few shops can actually do mandrel bending. What most places do is buy sections of pipe pre-bent from places such as Summit or Jegs, and then cut them and weld them together to get the shape you desire. Truck supply stores generally have them too for a little bit cheaper.
Originally Posted by Birdie2000
Lanes does exactly what I described. He buys pipes that were already mandrel bent, then pieces them together. 
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
10 Second Club
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
Originally Posted by calongo_SS
Thanks, I talked to Lanes today, he's doing a system for someone else with FLP's tomorow, so he'll have a model for me. 
Thanks,
Craig
Thanks,
Craig
TECH Fanatic
Joined: Oct 2003
Posts: 1,655
Likes: 0
From: Northern Va
if you dont go mandrel bent, you just gotta make sure the exhaust shop you take it to measures, measures, measures a little bit more then does it again jsut for good measure. that way the bends aren't too extreme and cause any kinks.
I had a mandral bent custom 3 inch y pipe made with a cut out in the I pipe through a hooker catback and when i went to the non mandrel bent off road x pipe with bullets and even over the cutout i still felt a gain across the rpms. plus it just sounds better. And i'd imagine that a 3 inch off road x pipe would work even better if you can't have the piping mandral bent.
have you thought about using the Dr Gas X pipe? its a decent amount of money but its mandrel bent and u can dump mufflers right off of it. its definately a quality peice. and will probably end up being cheaper than having a shop custom fab something for you.
I had a mandral bent custom 3 inch y pipe made with a cut out in the I pipe through a hooker catback and when i went to the non mandrel bent off road x pipe with bullets and even over the cutout i still felt a gain across the rpms. plus it just sounds better. And i'd imagine that a 3 inch off road x pipe would work even better if you can't have the piping mandral bent.
have you thought about using the Dr Gas X pipe? its a decent amount of money but its mandrel bent and u can dump mufflers right off of it. its definately a quality peice. and will probably end up being cheaper than having a shop custom fab something for you.