PCV assembly removal??
Thread Starter
Teching In
Joined: Oct 2007
Posts: 14
Likes: 0
From: Modesto, CA
PCV assembly removal?? Anybody have any tips on how to remove the PCV assembly from the rear of the driver side valve cover? I can't gain access to the elbow attached to the grommet.
I tried searching but I was only able to find catch can write ups that assumed the old PCV assembly had already been removed. If anybody has or knows where to find instructions on how to build your own new assembly, that would be great also.
I tried searching but I was only able to find catch can write ups that assumed the old PCV assembly had already been removed. If anybody has or knows where to find instructions on how to build your own new assembly, that would be great also.
Thread Starter
Teching In
Joined: Oct 2007
Posts: 14
Likes: 0
From: Modesto, CA
Finally got it. Super tight back there and the wiring harness was preventing it from pulling straight up and out. Was in there pretty snug, I used a flat screwdriver to pry it out.
Thank you for the replies.
Thank you for the replies.
