headers install cost
Thread Starter
Teching In
Joined: May 2005
Posts: 37
Likes: 0
headers install cost Hi, I was wondering about how much some speed engineering lone tube headers would cost to install to a 2k t/a? I'm tring to find someone who will do it too. Location NE Arkansas.
My 02 Z28 is having Speed Engineering 1 7/8 headers installed this week. Can probably give an accurate answer by end of week. Estimate was $350 to $500 depending on how well or how bad they fit.
My guess is $400
My guess is $400
Trending Topics
Long tubes took me about 2 hours to install.... Hardest part was trying NOT to break the manifold bolts off. If I remember right, driver side went in from the top and passenger side had to go in from the bottom..... I think.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Speaking of exhaust manifold bolts I had no issues removing the exhaust manifold bolts on my LS1 however the engine and trans was sitting on the k-member and rolled out from under the car before removing them. The 5.3 I pulled already had broken off bolts in both cylinder heads but the ones in the middle came out fine. Just be careful when removing them and be sure to tap on your tool at the same time your turning to help break the seal on the threads. If you break them off in the heads your going to have a lot of fun trying to remove them with the engine in the car.
Two exhaust manifold bolts broke and that added $200. If i'd tried at home, those two broke bolts would have been beyond my skill level to extract without help
I'm happy with the install.
There are plenty of how to's, and youtube videos on how to do it. It is a pig though, you have to get the car fairly high up, and then it's pain to get the headers weaved passed everything. A lift or twelve ton jack stands help. You need patience in spades. Can definitely understand wanting someone else to do it.
You might as well put poly motor mounts in while you're in there, if you don't have them already. Having the collector bang on the floor will suck, and speaking of pigs to do: Try putting motor mounts in with headers in the way, after you discover your driver's side collector hits the floor under load and at idle.
You might as well put poly motor mounts in while you're in there, if you don't have them already. Having the collector bang on the floor will suck, and speaking of pigs to do: Try putting motor mounts in with headers in the way, after you discover your driver's side collector hits the floor under load and at idle.
Staging Lane
Joined: Mar 2011
Posts: 68
Likes: 4