07BlueDevilZ06

iTrader: (8)

I finaly built my 3.5 x 3 inch x pipe exhaust. I have the big stepped 1 7/8-2 inch kooks headers with the 3.5 colectors. Which i teamed up with 3.5inch mandrel bent tubing i flattend the driverside tube to allow more ground clearence. that went in to my 3.5 x pipe. Then stepped down to 3 inch to increase the velocity. That went to my 2 full size welded spintech mufflers and out of the mufflers with 2 mandral bent 3 inch turndowns. After doing it i think we can easly reproduce this for our customers in a 3.5x3,3x3 or 3x2.5 version for our customers. prices should start in the $750.00 range installed
and remember this is a full sized muffler not a bullet and will pass 90db tech.

george

Hawkn01

iTrader: (1)

Interesting George, do you have any pics ? Hows the ground clearance ?

I pondering what to do with my 3.5" collectors. I was looking at the Dr. Gas Winston Cup oval x-pipe and oval tubing but man is that stuff pricey.

TJ

TTPMatt

iTrader: (18)

TJ: I'll take some pictures and post them a bit later.

Hawkn01

iTrader: (1)

Thanks Matt.