Anyone using SLP LS6 intake and !EGR?
Thread Starter
Launching!
Joined: Nov 2001
Posts: 280
Likes: 0
From: North Royalton, Ohio
Anyone using SLP LS6 intake and !EGR? I have an SLP LS6 intake with their EGR hookup on it, but I have deleted my EGR. Can anybody tell me what to use to plug the fitting? I suppose a freeze plug might be the way to go, but there is already a threaded nozzle on the intake if I could find an appropriate threaded cap for it. Any insights would be appreciated. Thanks!
go to any auto/hardware store and look for a plug for that size. It's like a thick fat rubber washer with metal washers on top and bottom with a nut and bolt sorta gizmo going through it. You put it in the hole and then tighten the nut until the washers squeeze the plug enough for a snug fit. And then you're done!!!
Hope this info helps
Hope this info helps
Originally Posted by Another_User
It is a 1 3/8 expanding freeze plug. It is black rubber with a metal washer looking top and a nut in the middle.
Thread Starter
Launching!
Joined: Nov 2001
Posts: 280
Likes: 0
From: North Royalton, Ohio
I thought the 1 3/8" plug was for LS1 intakes.... The EGR adaptor looks smaller than that. I was hoping to find a cap that would screw onto the brass fitting. I will try the freeze pluge route.... hopefully it works.
TECH Addict
Joined: Feb 2004
Posts: 2,826
Likes: 0
Originally Posted by LS1_SS
how much is it?
