ELS1

its a small hose that goes into the intake manifold AFTER the maf(below where the EGR goes into the intake)...i have a little hole in it and its makin my car run lean.

anyone know if i can just apply liquid electrical tape to it to seal it? its VERY smal...

btw, how hard will it be to replace? ust take off the MAF and pull it out with pliers? thanks




99 ls1

LawmanSS

iTrader: (19)

Is it the hose that runs to the passenger side valvecover?

If so, part # 12558454 (according to parts manual for m/y 1999)...

ELS1

yea...and does it go into the intake manifold? do u happen to have a pic of that page scanned so i can look?

ELS1

here is the pic taken from installuniversity...circled yellow...its a small piece

LawmanSS

iTrader: (19)

OH...that little piece is to connect the PCV valve to the intake...according to the parts manual, that little rubber elbow is not available separately, but is part of the PCV hose assembly. I would think that you could use some regular fuel line hose to make that connection.